<div dir="auto"><div dir="auto">On Fri, 6 Sep 2019, 22:42 Jan Michel, <<a href="mailto:jan@mueschelsoft.de">jan@mueschelsoft.de</a>> wrote:</div><div dir="auto">> We do have a (recently approved) relation type for this: 'connectivity':</div><div dir="auto">> <a href="https://wiki.openstreetmap.org/wiki/Relation:connectivity">https://wiki.openstreetmap.org/wiki/Relation:connectivity</a></div><div dir="auto"><br></div><div dir="auto">Thank you, this is exactly what i was looking for! (Although, as you wrote, it doesn't seem necessary in this case.)</div><div dir="auto"><br></div><div dir="auto">On Fri, 6 Sep 2019, 22:07 Leif Rasmussen, <<a href="mailto:354lbr@gmail.com">354lbr@gmail.com</a>> wrote:</div><div dir="auto">> I see two good options: </div><div dir="auto">> 1) Split the two lanes into two ways where they first split apart (but aren't yet physically divided).  This doesn't follow the "physical divider" rule, but since the road markings are acting as a physical divider, and they are much more than just a line, an exception to that rule seems fine.</div><div dir="auto"><br></div><div dir="auto">IMO it's better to not make an exception. Otherwise sooner or later there will be no rule anymore.</div><div dir="auto"><br></div><div dir="auto">> I've been considering starting a proposal for mapping the widths of lane dividers recently, since there are many cases where they aren't just lines.  Perhaps some tag like "width:dividers=0|0|4" or similar could work, where each number represents a divider between two lanes [...] I personally think something other than "|" should be used for dividers, so am looking for a better syntax.</div><div dir="auto"><br></div><div dir="auto">That seems fine – with vertical bars –, but i guess it should rather be dividers:width=* (instead of width:dividers=*). Besides, i think it shouldn't be 0 if lane dividers aren't absent (better e.g. 0.01|0.01|4). And it may not work well if the with of a divider increases or decreases, what is the case quite often (e.g. triangle with chevrons or diagonal bars). But maybe something like dividers:width:start=* dividers:width:end=* could be used if the increase is linear.</div><div dir="auto"><br></div><div dir="auto">Regards</div><div dir="auto">Markus</div></div>