[Tagging] Ways rendered on wrong layer (counter to the layer tag values)

Nathan Edgars II neroute2 at gmail.com
Fri Aug 20 19:41:11 BST 2010


On Fri, Aug 20, 2010 at 7:20 AM, Andrew Harvey <andrew.harvey4 at gmail.com> wrote:
> I'm not sure when to use the bridge tag. In this part of the map
> http://c.tile.openstreetmap.org/17/120570/78686.png there is a footway
> which is at ground level at both ends, but significantly above the
> water below in the middle, held up by pylons. I tagged it with
> bridge=yes, layer=1. Then there is the motorway (in blue) which is
> above the footway bridge, it is tagged layer=2, but not as a bridge.
> But the renderer puts the layer=2 below the layer=1. I was assuming
> this is because the motorway has not been tagged with bridge=yes. How
> can I get the footway to render below the motorway? Or should I just
> tag that part of the motorway as bridge=yes too.

http://trac.openstreetmap.org/ticket/2601



More information about the Tagging mailing list