[OSM-newbies] Coastline issues?

[David Groom]

----- Original Message ----- 
From: "David Fawcett" <david.fawcett at gmail.com>
To: <newbies at openstreetmap.org>
Sent: Friday, December 04, 2009 3:06 PM
Subject: [OSM-newbies] Coastline issues?


>
> I have been cleaning up the harbor coastline near Duluth, MN, USA.
> http://www.openstreetmap.org/?lat=46.75019&lon=-92.06778&zoom=15
>
> When I look at the Osmarender layer to see how my edits were rendered,
> the water is not symbolized.  My guess is that I did something to
> screw up the topology of the coastline.
>
> One suspect edit is where the coastline followed a high bridge across
> the harbor.  I removed the segment of way that incorrectly connected
> the two sides of the harbor and tried to connect the ways denoting
> each side of the bay underneath the bridge on their respective sides.
>
> Can anyone take a look at this and confirm that this is the case (or
> suggest what the problem could be?
>

David

One coastline way was triplicated.  and in one way there was a small gap 
between the end of the way and the start of the next section of coastline.

I've fixed these issues 
http://www.openstreetmap.org/browse/changeset/3289175 nad asked for the 
osmarender layer to be re-rendered , so we'll see how it looks a bit later.

David


> I hate to revert back because I did a lot of detailed tracing.  I
> would much rather just fix the issue.
>
> Thanks,
>
> David.
>
> _______________________________________________
> newbies mailing list
> newbies at openstreetmap.org
> http://lists.openstreetmap.org/listinfo/newbies
>
>