[OSM-newbies] Forest area not showing up

[Kenneth Pardue]

Still have to wait for all the zoom levels to render, but that seems to have fixed it.  Not only for that area, but I was able to do the same for the other four areas in Louisiana.  National Forest boundaries now in Louisiana, yay!  Now I need to go back and continue work on importing the water data.


On Dec 14, 2010, at 4:53 PM, Craig Wallace wrote:

> On 14/12/2010 14:29, Kenneth Pardue wrote:
>> I've imported data from the USGS for the Kisatche National forest in
>> my area, but for some reason it's not showing up in the renderer.  I
>> have landuse=forest, and in Potlatch it shows up with green shading
>> as it should, but I noticed that when I click on the forest outline
>> in Simple mode I don't get the "area" type of tags.  Is there
>> something I'm missing here?  I can't find any disconnected nodes.
>> See the lower left hand corner of it here:
>> http://www.openstreetmap.org/?lat=31.4182&lon=-92.3591&zoom=14&layers=M
> 
> The two ways that make up the multipolygon are not connected at their
> end of one, ie there is a little bit sticking out.
> 
> Specifically, at this point:
> http://www.openstreetmap.org/?lat=31.471955&lon=-92.297031&zoom=18&layers=M
> Look at it with the Data layer or in an editor, and you can see the
> little extra bit. Just delete that extra node, and should make it a
> proper polygon, so should render properly.
> 
> I think the tagging of the area is fine.
> 
> 
> Craig
> 
> _______________________________________________
> newbies mailing list
> newbies at openstreetmap.org
> http://lists.openstreetmap.org/listinfo/newbies